발행물

전체 논문

159

61

Dynamics modeling and structural analysis of underwater construction robot
Sung-Min Hong, Hyeon-Seok Kang, Do-Sik Shim, Hyeung-Sik Choi, Joon-Young Kim
Int. J. of Modern Phisics B, 2018

62

Conical Roll-Twist-Bending Process for Fabrication of Metallic Archimedes Spiral Blade Used in Small Wind Power Generator
Sung-Moon Yang, Ho-Seong Ji, Do-Sik Shim, Joon-Ho Baek, Sang-Hu Park
Int. J. of Precision Engineering and Manufacturing-Green Technology, 2017

63

Effect of substrate preheating by induction heater on direct energy deposition of AISI M4 powder
Do Sik Shim*, Gyeong Yun Baek, Eun Mi Lee
Materials Science & Engineering-A (IF 3.094), 2017

64

Study on the Mechanical Characteristics of a Deposited Tool Steel Layer Deposited using Direct Energy Deposition
Gyeong Yun Baek, Gwang Yong Shin, Eun Mi Lee, Do Sik Shim*, Ki Yong Lee, Myoung Ho Kim
Metals and Materials International (IF 1.889), 2017

65

Study of the effects of process parameters on deposited single track of M4 powder based direct energy deposition
Eun Mi Lee, Gwang Yong Shin, Do Sik Shim*
J. of Mechanical Science and Technology (IF 1.128), 2017

66

Improvement strategy for edge waviness in roll bending process of corrugated sheet metals
Do-Sik Shim*, Jong-Youn Son, Eun-Mi Lee, Gyeong-Yun Baek
Int. J. of Material Forming (IF 1.978), 2017

67

Influence of heat treatment on wear behavior and impact toughness of AISI M4 coated by laser melting deposition
Do-Sik Shim*, Gyeong Yun Baek, Seul-Bi Lee, Jae-HyunYu, Yoon-Suk Choi, Sang-Hu Park
Surface and Coating Technology, 2017

68

Effects of Substrate Preheating During Direct Energy Deposition on Microstructure, Hardness, Tensile Strength, and Notch Toughness
Gyeong Yun Baek, Ki Yong Lee, Sang Hu Park, Do Sik Shim*
Metals and Materials International, 2017

69

Effect of layer thickness setting on deposition characteristics in direct energy deposition (DED) process
Do-Sik Shim*, Gyeong-Yun Baek, Jin-Seon Seo, Gwang-Yong Shin, Kee-Poong Kim, Ki-Yong Lee
Optics & Laser Technology (IF 2.109), 2016

70

Double-stage forming using critical pre-bending radius in roll bending of pipe with rectangular cross-section
Do-Sik Shim*, Kee-Poong Kim, Ki-Yong Lee
J. of Materials Processing Technology (IF 3.147), 2016